Burning (Burn Files)
To perform this operation it is necessary to load a compact disk into
recording device, set this device as recorder, choose the type and
parameters of burning and press Burn button.
Disk burning management controls are listed below:
- Recorder
Recording device with inserted compact disk on which the project is
required to be burn. Use button Select... which is located near
the device description to choose correct device.
- Speed
- Allows to choose the write speed of compact disk. Write/read speed of
compact disks is specified as coefficient to the minimal speed for this
type of media. Maximal speed (MAX) is an optimal choice in most cases
while using BURN-Free technology. In
case of errors during burning compact disk or usage of computer during
burning disk is planned, it is possible to lower the write speed, using
button Select... near the speed value.
- Blank disk before burning
- Rewritable disk will be fast blanked before burning.
- Verify media after burning
- After burning is complete reads a media content being burned to check
the data is intact. It's handy to make sure you don't have bad media.
Reports any errors detected (if any).
- Finalize disk
Further burning of disk becomes impossible. If it is planned to add more
data on disk later, this option must be turned off. Non-finalized disk
allows to add more data and is called multisession disk. You have
to remember that some devices can read only first session of data from such
disks.
- Clear project after burning
Clears the project after a successful burning.
- Eject disk after burning
Disk will be ejected after completion of the burning.